KOMOBI Device Setup
Steps for proper configuration:If you haven't installed your device on your motorcycle yet, go to the device installation article.
If you have already installed the device on your motorcycle and followed the steps described in the device installation article, you can proceed with the following:
- Pair your device with the QR code shown on the welcome card.
- Wait for a few minutes until the device connects to our servers to initiate the configuration process.
- Vertical calibration. In this step, you need to keep your motorcycle completely upright, preferably without the support of the kickstand or center stand. When your motorcycle is straight and completely still, click on START CALIBRATION.
- Horizontal calibration. This step involves tilting your motorcycle about 10 degrees to the left. When the countdown timer of 10 seconds finishes, tilt your motorcycle. It should be a smooth motion—just tilt your motorcycle and immediately bring it back up. When the motorcycle is upright again, click on FINISH CALIBRATION.
ATTENTION!: You must watch the indicated video in order to click on the gray checkmark.
CONGRATULATIONS! You have successfully completed the configuration process. From now on, you will be able to enjoy all the functionalities of KOMOBI.
