Where can I install my device?

Where can I connect KOMOBI?

Recommendations

• • • Connect the device directly to the battery terminals.
    • Avoid using locations under the gas tank or covered by metal.
    • Clean the area where the device will be attached to ensure proper adhesion.
    • The device can be positioned in any orientation, but it should be placed on flat surfaces.

Other Installations

Although the KOMOBI team recommends direct installation to the battery terminals, our device can work with voltages between 7.5V and 14V. Therefore, any power source that provides this range of values can be used as a connection for the device.

Here are some examples of where you can connect your device if you prefer not to connect it directly to the battery terminals of your motorcycle:

• • • Light circuit.
    • 12V auxiliary outlets.
    • Ignition wiring.

Essentials for Installation

1. Device
2. Keychain
3. Quickstart card
4. Mobile phone with the KOMOBI app installed
   
   

Installation Steps

1. Go to your App Store (for iOS devices) or Google Play (for Android devices) and download our KOMOBI app.
2. Create a user account. Note: If you have registered previously on our website, you will need to create a new user account. The user account registered on the website is not linked to the app.
   
   
3. Access the app with your chosen username and password.
4. Follow the steps outlined in the app.
   
   
5. Find yourself in an outdoor location.
   
   
   You should click on the gray checkmark to confirm that you are following the instructions
   
   
6. Place the device in the chosen area using the adhesive it comes with.
7. Connect the black cable to the negative terminal of the chosen power source (recommended: black terminal of your motorcycle's battery).
8. Connect the red cable to the positive terminal of the chosen power source (recommended: red terminal of your motorcycle's battery).
   
   
9. From this point onwards, continue with the article Device Configuration.